Module Features:
- based on the 9S12C128 MCU (48-pin LQFP version)
- includes 8 Mhz crystal
- 24 MHz bus speed (via PLL)
- local 5 Volt low-dropout 100 mA regulator
- includes RS232 transceiver circuit
- includes CAN transceiver circuit
- has on-chip Serial Monitor
- supports standalone operation
- 128K Bytes Flash
- 4K Bytes Ram
- 40-pin DIP form-factor
- pinout is super-set of competing 24-pin modules on the market
Ease-of-Use Features:
- supports programming in C, BASIC, Forth, assembler, etc.
- no special Flash programming voltage or switch required
- fast in-circuit programming
- small footprint on-chip bootloader/monitor and free uBug12 GUI for quick loading/debugging of user programs on a Windows platform
- Run/Load switch for choice of Standalone or Monitor operation following reset
- compatible with virtually all 9S12 development tools on the market
Additional Features
- implements PLL loop filter circuit, supporting up to 48MHz operation (24 MHz bus speed)
- capable of 3-Volt operation (Note: CAN transceiver will not work at 3V)
- standard 6-pin BDM connector for full debugging capabilities (with an optional BDM pod)
- up to 31 digital I/O lines, including Port M, Port T, and Port E
- access to eight 10-bit analog input or digital I/O port lines (Port AD)
- access to eight digital I/O port lines (Port T)
- up to six PWM timer channels (PT0 - PT4, PP5)
- up to eight Input Capture/Output Compare pins (Port T)
- key wake-up interrupt pin (PP5)
- serial peripheral interface (SPI)
- serial communications interface (SCI)
- controller area network (CAN 2.0) (on-board transceiver circuit)
- internal programmable pullup and pulldown resistors on most pins
- user access to MCU reset signal
- sturdy gold-plated machine pins plug into standard dual-leaf DIP sockets or solderless breadboard
Plus more from:
http://www.technologicalarts.ca/catalog/product_info.php?cPath=50_36&products_id=348&osCsid=127e4fc1a2b2ba254a78e7d4ac80049b